US CPSC Proposes Changes to SRM for Mattress Flammability Standards
The US CPSC has voted to amend the Federal Standard for the Flammability of Mattresses and Mattress Pads (16 CFR Part 1632) updating flammability test requirements and the standard reference materials (SRM).
SAFEGUARDS | Consumer ProductsNO. 157/20
The US Consumer Product Safety Commission (CPSC) has voted to amend the Federal Standard for the Flammability of Mattresses and Mattress pads (16 CFR PART 1632)1.
The Commission voted unanimously (4-0) to approve publication of a notice of proposed rulemaking (NPR) to amend the Federal Standard2 by revising the ignition source cigarette specified for use in the Standard’s performance tests, Standard Reference Material (SRM) cigarette SRM 1196 with SRM 1196a3.
The need to replace the original SRM 1196 arose because the entire stock of SRM 1196 was depleted before National Institute for Standards and Technology (NIST) was able to complete a new procurement. However, NIST successfully procured SRM 1196a as a replacement for SRM 1196.
CPSC staffers did an exhaustive research with a pilot study followed a full-scale study to evaluate the ignition performance of new SRM 1196a. Based on the evidence provided by the full-scale study, pilot study, and NIST certification, as well as examination of CPSC compliance data and data from the 2010 transition from the original ignition source to SRM 1196, CPSC staff’s review showed that SRM 1196a cigarettes are statistically equivalent to SRM 1196. “On these bases, the Commission finds that SRM 1196a is a comparable, safety neutral replacement for SRM 1196.”
Comments on the proposed amendment could be submitted no later than 75 days after date of publication in the Federal Register.
For enquiries, please contact:
SGS Consumer and Retail
Deputy Vice President
Stay on top of regulatory changes within your industry: subscribe to SafeGuardS!
Read more articles for the Consumer Goods and Retail industry
© SGS Group Management SA - 2020 - All rights reserved - SGS is a registered trademark of SGS Group Management SA. This is a publication of SGS, except for 3rd parties’ contents submitted or licensed for use by SGS. SGS neither endorses nor disapproves said 3rd parties contents. This publication is intended to provide technical information and shall not be considered an exhaustive treatment of any subject treated. It is strictly educational and does not replace any legal requirements or applicable regulations. It is not intended to constitute consulting or professional advice. The information contained herein is provided “as is” and SGS does not warrant that it will be error-free or will meet any particular criteria of performance or quality. Do not quote or refer any information herein without SGS’s prior written consent.