Revision to the US Toy Standard Published as ASTM F963-17
SAFEGUARDS | Toys & Juvenile Products NO. 142/17
ASTM F963 has been revised to include editorial changes and clarify requirements for Kinetic Energy Density.
The main reason for the revision was to clarify that the new Kinetic Energy Density (KED) is only applicable to projectile toys and arrows that have a kinetic energy greater than 0,08J. This in order not to impose unnecessary testing. The requirements for KED are to be found is section 220.127.116.11 and 18.104.22.168.
Other changes made have been more editorial and/or for clarification.
Some examples of these changes are:
The word “must” was changed in “shall” to emphasize the mandatory status of the standard
A listing of microbiological standards has been added to the referenced documents in sec. 2
Clarifying that eye shadow or lip gloss intended to be applied on a doll’s face is not subject to FDCA labelling requirements
The definition of “driving mechanism” was deleted as it is no longer used in the standard
Setting only one condition to define a low power circuit by deleting the condition not to exceed 15W at the end of 5 minutes.
Rewording charging and discharging conditions for batteries in 22.214.171.124
Several other editorial changes
The ASTM F963-17 is a revision of ASTM F963-16. The ASTM F963-16 version became mandatory on 30 April 2017. ASTM officially notified CPSC on Friday, September 1, that a revised ASTM F963 was published as ASTM F963-17. CPSC now has 90 days to accept or reject this revised standard. ASTM F963-17 standard will then become a mandatory requirement after 90 days from when the Commission accepts this revised standard.
SGS is committed to providing information about development in regulations for consumer products as complimentary services. Throughout the SGS global network of laboratories, we are able to provide a wide range of services including physical/mechanical testing, analytical testing and consultancy work for technical and non-technical parameters applicable to a comprehensive range of consumer products. Please do not hesitate to contact us for further information.
Manufacturer, retailers, and distributors of toys would need to test to the requirements of the revised standard once it becomes a mandatory.
For enquiries, please contact:
Technical Director (Hardlines)
t: +1 (973) 461-7953
Stay on top of regulatory changes within your industry: subscribe to SafeGuardS!
Read more articles for the Consumer Goods and Retail industry© SGS Group Management SA - 2017 - All rights reserved - SGS is a registered trademark of SGS Group Management SA. This is a publication of SGS, except for 3rd parties’ contents submitted or licensed for use by SGS. SGS neither endorses nor disapproves said 3rd parties contents. This publication is intended to provide technical information and shall not be considered an exhaustive treatment of any subject treated. It is strictly educational and does not replace any legal requirements or applicable regulations. It is not intended to constitute consulting or professional advice. The information contained herein is provided “as is” and SGS does not warrant that it will be error-free or will meet any particular criteria of performance or quality. Do not quote or refer any information herein without SGS’s prior written consent.